Page 1 of 1

extra efficient RO filter

Posted: 18 Oct 2010, 07:59
by worton[pl]
Hello,

well I'm wondering what kind of water filters do you usually use in your fishrooms? I have 2 RO filters but they are not efficient because of amount of water around 6000 liters in my system. They just can't copy with all waterchanges I need. Is there any high efficient (around 1000l/day) RO unit or maybe you use other method of softering water?

Regards.

Re: extra efficient RO filter

Posted: 18 Oct 2010, 08:09
by MatsP
Something like this, perhaps?
http://www.osmotics.co.uk/6-stage-450-g ... p-444.html

--
Mats

Re: extra efficient RO filter

Posted: 18 Oct 2010, 13:14
by PlecoCrazy
Part of your problem could just be water pressure. I have a 100 gallon a day RO but with my water pressure I can only get about 20 a day. They make pumps to increase the pressure but I have not tried one yet as they are expensive.

Re: extra efficient RO filter

Posted: 18 Oct 2010, 13:35
by MatsP
Trent makes a good point.

With regards to the "Other options", it seems that using RO is the by far most cost-effective way to produce soft water (unless water is prohibitly expensive, as RO water also produces a large amount of waste-water, which can be difficult).

--
Mats

Re: extra efficient RO filter

Posted: 05 Nov 2010, 13:00
by dw1305
Hi all,
You could try rain-water. I've always used it, but I live in a rural area of the SW UK.
cheers Darrel

Re: extra efficient RO filter

Posted: 05 Nov 2010, 13:27
by MatsP
I think you need a very large collecting area to guarantee enough water for a moderate 25% water change on a 6000 liter system. Not to mention large storage butts.

--
Mats

Re: extra efficient RO filter

Posted: 06 Nov 2010, 23:23
by apistomaster
I would want at least 3 or 4 55 US gal/208 liters plastic water barrels of storage capacity for a 6000 liter system.
A 300 US gal/1000 liters per day RO system would be nice because it can operate at a little less than ideal conditions and still meet most needs. Any RO system of that capacity should include or be designed to use a pressure pump to operate the RO unit at optimum pressures/capacity. The hard part of obtaining optimum RO unit performance is being able to use warmer water than most main water supplies run during the winter. I know my unit is more productive during the summer than it is in the winter.
I am watching for deals because I hope to get a high output RO unit in the near future. My small 60 US gal/227liters per day RO unit is close to needing a new membrane and it is better to apply that expense to a much higher out RO unit.
I have about half as much water but it is always nice to minimize the time it takes to refill your RO reservoirs.
My city water is softer now than it has been in the past. They are drawing from a different well and my TDS has dropped from the old 340 ppm down to only 225 ppm TDS. 225 ppm TDS is not all that bad for from the tap water.